Question 1

Do I need a permit for painting, flooring, new cabinets or countertops in Danville?

Accepted Answer

Usually no permit - this is finish work. California's code lists painting, wallpaper, tile, carpet, cabinets, countertops and similar finish work as not needing a building permit. If the job also moves plumbing, adds outlets or circuits, or removes a wall, that part needs a permit. Check with the Danville Permit Center before you start.

Question 2

Do I need a permit for kitchen or bathroom remodel in Danville?

Accepted Answer

Depends on the work - cosmetic updates usually don't; moving pipes, wiring or walls does. No permit for swapping cabinets, countertops, tile, flooring and paint. A permit is needed for new or moved plumbing, new circuits or outlets, new gas lines or venting, and removing or adding walls. Most full remodels need at least plumbing and electrical permits. Check with the Danville Permit Center before you start.

Question 3

Do I need a permit for plumbing repair (leak, clog, toilet) in Danville?

Accepted Answer

Small repairs usually don't; replacing pipes does. No permit to stop a leak, clear a clog, or remove and reinstall a toilet - as long as no pipes, valves or fixtures are replaced or moved. Replacing a hidden pipe or trap, repiping, or adding fixtures needs a plumbing permit. Check with the Danville Permit Center before you start.

Question 4

Do I need a permit for replacing an appliance in Danville?

Accepted Answer

A plug-in swap usually doesn't; new gas, water, venting or circuits do. Swapping an appliance that plugs into the existing outlet, water or gas connection usually needs no permit. A new gas line, new circuit or outlet, new venting or a new water line needs a permit. Check with the Danville Permit Center before you start.

Question 5

Do I need a permit for water heater replacement in Danville?

Accepted Answer

Yes - replacing a water heater needs a plumbing permit (and sometimes electrical). This applies to like-for-like replacements too. A heat pump water heater usually also needs an electrical permit for its circuit. Your plumber normally pulls the permit, and an inspector checks the venting, gas line and earthquake strapping. Check with the Danville Permit Center before you start.

Question 6

Do I need a permit for furnace, ac or heat pump replacement in Danville?

Accepted Answer

Yes - replacing heating or AC equipment needs a permit in California. This covers the furnace, air handler, coil, condenser or heat pump, including like-for-like changeouts. California energy rules may also require duct testing. Your HVAC contractor normally pulls the permit. Check with the Danville Permit Center before you start.

Question 7

Do I need a permit for electrical panel upgrade in Danville?

Accepted Answer

Yes - a panel or service upgrade needs an electrical permit. The utility often has to disconnect and reconnect service, which needs the city's sign-off. Swapping a breaker for one of the same size in the same spot doesn't need a permit. Check with the Danville Permit Center before you start.

Question 8

Do I need a permit for ev charger (level 2) in Danville?

Accepted Answer

Yes - a hard-wired charger or a new 240-volt circuit needs an electrical permit. California requires cities to offer a streamlined permit for home EV chargers. Plugging a charger into an existing outlet that's already rated for it doesn't need a new permit. Check with the Danville Permit Center before you start.

Question 9

Do I need a permit for solar panels or home battery in Danville?

Accepted Answer

Yes - solar and battery systems need building and electrical permits. Many cities offer fast or instant online approval for standard home solar. Your installer normally handles the permit and the utility's approval to turn it on. Check with the Danville Permit Center before you start.

Question 10

Do I need a permit for roof replacement in Danville?

Accepted Answer

Yes - replacing the roof (a re-roof) needs a permit. Small repairs, like replacing a few shingles, usually don't. A full tear-off or new layer does, and is inspected. Historic homes may need planning approval first. Check with the Danville Permit Center before you start.

Question 11

Do I need a permit for window replacement in Danville?

Accepted Answer

Depends on the city and the work - check before you order. Many cities require a permit to replace windows, mainly to check energy and safety-glass rules. Making an opening bigger, or adding a new window, needs a permit everywhere. Historic homes and some neighborhoods need planning approval. Check with the Danville Permit Center before you start.

Question 12

Do I need a permit for fence in Danville?

Accepted Answer

Fences up to 7 feet usually need no building permit - but height limits still apply. California's code exempts fences up to 7 feet tall from a building permit. Zoning rules still limit height, especially in front yards and near driveways and corners - often much lower than 7 feet. Fences on retaining walls, or over 7 feet, need a permit. Check with the Danville Permit Center before you start.

Question 13

Do I need a permit for deck in Danville?

Accepted Answer

Small, low, freestanding decks usually don't; others do. No building permit for a deck up to 200 square feet, no more than 30 inches above the ground, not attached to the house, and not serving a required exit door. Attached, raised or larger decks need a permit. Check with the Danville Permit Center before you start.

Question 14

Do I need a permit for shed or small backyard building in Danville?

Accepted Answer

One-story sheds of 120 square feet or less usually need no building permit. Bigger sheds, and any shed with electricity or plumbing, need a permit. Zoning rules on setbacks from property lines and height still apply. Check with the Danville Permit Center before you start.

Question 15

Do I need a permit for retaining wall in Danville?

Accepted Answer

Up to 4 feet (from the bottom of the footing) usually doesn't, unless it holds extra load. Walls over 4 feet, or walls holding up a slope, driveway or building above, need a permit and often an engineer. Check with the Danville Permit Center before you start.

Question 16

Do I need a permit for driveway, walkway or patio (concrete or pavers) in Danville?

Accepted Answer

On your own lot, usually no building permit. California's code exempts sidewalks and driveways from a building permit. Work on the curb, the driveway apron or the public sidewalk needs a city public works permit. A raised patio, or a patio cover, may need a permit. Check with the Danville Permit Center before you start.

Question 17

Do I need a permit for tree removal in Danville?

Accepted Answer

Depends on the tree's size and type - many Silicon Valley cities protect larger trees. Many cities require a permit to remove larger trees, street trees, or protected species like oaks, even if the tree is dead. Trimming usually doesn't, but heavy pruning of a protected tree may. Check your city's tree rules before any removal - fines can be high. Check with the Danville Permit Center before you start.

Question 18

Do I need a permit for adu or garage conversion in Danville?

Accepted Answer

Yes - ADUs and garage conversions need permits and plans. State law makes ADUs easier to approve, but you still need building permits. Many cities have pre-approved ADU plans. Check with the Danville Permit Center before you start.

Question 19

Do I need a permit for room addition or removing a wall in Danville?

Accepted Answer

Yes - additions and structural changes need permits and usually plans. Removing or moving a wall, especially a load-bearing one, needs a permit. Check with the Danville Permit Center before you start.

Do I need a permit in Danville?

Inside

Systems & energy

Outside & yard

Big projects